To use this simple tool, just pull a Tinder-Quik tab from the plastic case and ignite with the Spark-Lite. Tinder-Quik is waterproof and will burn for 1-2 minutes giving you plenty of time to get your fire started. The Spark-lite will even work with a variety of materials you can find outdoors such as milkweed and other fibrous materials. The Spark-Lite also allows for easy single handed operation. It is designed to spark hundreds of times and may be used with either the right or left hand.
When you scrape the striker down the high performance flint material, you generate a spark three times as hot as a standard match which will easily ignite any dry tinder material. Or, you can use the included WetFire™ tinder which burns at more than 1300 degrees. We challenge you to find a better non-toxic, odorless tinder that actually burns longer when wet! You won’t find it.
When conditions are at their worst you can count on StrikeForce® to make you a warming fire. It also is a safe and easy lighter for your backpacking stoves or barbecues. At less than four ounces, a StrikeForce® is an essential when you’re putting together a survival kit, gathering your camping gear, or even if you just plan to go hiking. A StrikeForce® fire starter should be in the pocket of everyone who does anything outdoors. The StrikeForce® is proud to be made in the U.S.A.The name "StrikeForce" is registered with the U.S. Patent and Trademark Office, No. 5,279,628.
SPECIFICATIONS• Length: 5 inches (12.7 cm)• Weight:
3.7 ounces (104.9g)• Material, Flint Unit: 0.5-inch (1.3 cm)
diameter flint bar embedded in ABS case• Material,
Tinder: Trade secret material
It is actually a stainless steel parabolic mirror, just like the one used to light the Olympic torch in Athens. It is designed to focus the sun's radiant energy to a precise focal point that can reach hundreds of degrees!
O ring. Which to choose..? Both types of fire pistons will ignite quickly and easily.
A string gasket is the traditional method for achieving an air tight piston seal. This method is very effective, however the gasket does require occasional lubrication with Vaseline to maintain top performance. With extended use the gasket will eventually wear and need to be replaced. Its takes about five minutes to re-wrap a worn string gasket and restore original performance.
Rubber O rings are well known for their sealing ability and they perform
very well in fire pistons. While not traditional, they are easier to replace
than a string gasket and require less frequent lubrication. Because O rings
seal more effectively than string gaskets it is not possible to fully insert
the piston after use due to trapped air. Pistons with O ring seals tend to
pop out of the cylinder a short distance.
*Tinder carry not included*
